 Topic: MRDS-Magnetic dent balls
|
 
|
| Author |
|
misel
Newbie
Joined: February.14.06
Location: Denmark
Online Status: Offline
Posts: 5
|
| Posted: September.05.06 at 2:22am | IP Logged
|
|
|
Hello!
I am new to this page, so hello to everybody.
I am a brass technician and I am thinking about buying the MRDS-Magnetic dent removal system. You can buy it at jlsmithco.com.
I am just wondering if this system is any good, because it is pretty expensive.
Anyone have any experience with this system?
Kind regards
Jean-Michel
|
| Back to Top |
|
| |
admin
Admin Group
Joined: March.10.05
Location: USA
Online Status: Offline
Posts: 304
|
| Posted: September.08.06 at 7:10pm | IP Logged
|
|
|
Hi Jean-Michel,
The magnetic dent removal system is extremely useful and time saving. It gives you the ability to remove dents in previously inaccessible areas without unsoldering. However, it will not replace the conventional methods of dent removal of threaded rods and balls and dent ball sets. These will still have their place in the shop.
Michelle
|
| Back to Top |
|
| |
|
|
If you wish to post a reply to this topic you must first login
If you are not already registered you must first register
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum
|
Powered by Web Wiz Forums version 7.9Copyright ©2001-2004 Web Wiz Guide
This page was generated in 0.0625 seconds.
|
(0.0)
Active Topics
Memberlist
Search
Help
